The outboard finally died, and that is usually when a Mississippi owner stops calling it a boat and starts calling it a problem. Along the Gulf Coast, from canal pulls near Biloxi to marina slips further inland, a dead motor turns a hull into dead weight fast, especially once hurricane season adds storm-damaged boats to the list. Nobody wants a hull with no engine and no way to move it.
That is fiberglass boat disposal, start to finish, motor or no motor. We tow the hull out whole, cut it down at our yard, and send the material on to a processor. Missing paperwork does not stop the job, we work through that after hurricane season along with everyone else.
Fiberglass boat disposal pricing in Mississippi
Mississippi, starting at$400+Firm quote from photos.
Hull lengthUnder 20 ft is quick. 20+ ft needs cuts and more time.
LocationDriveway on flat ground is simplest. Ramp haul-outs cost more.
ConditionSoft transoms, missing floors, hardware pulled — all changes the cut.
DistanceMiles to our yard. Longer haul, higher line item.
Local read — Mississippi
Along the Gulf Coast, hauls to our processing yard tend to run short, so distance rarely moves your number in Mississippi. What matters more is access, a canal pull or marina slip job near Hattiesburg can take more crew time than a driveway pickup, and hurricane season backs up our schedule every fall. A dead motor with no salvage value just means the whole hull counts as one job. Send photos, hull length, and your ZIP.
What we take in Mississippi
Bowriders & runabouts18–22 ft fiberglass hulls, gelcoat oxidized, transom soft.
Cuddy cabins & cruisers24–30 ft glass hulls with sunken interiors or dead motors.
Center consoles & bay boatsCoastal glass hulls with cracked stringers or floor rot.
Fiberglass sailboatsTrailer-sailors and small keels ready to be cut down.
Missing paperwork or a stalled restoration doesn't hold up the pickup.
One number for pickup, transport, cutting, and disposal. No hourly, no fuel surcharges after.
3
Schedule the tow
We coordinate the pickup window. The crew calls when they're an hour out.
4
Haul to our yard, cut it down
Hull comes off in one piece when it can, then it's cut into sections at our yard. No cutting torches in your driveway.
5
Recycle what routes, dispose of the rest
Metal fittings and hardware recycled. Fiberglass goes to a processor equipped for it.
Fiberglass disposal in Mississippi: FAQ
How much does it cost to get rid of an old fiberglass boat in Mississippi?
In Mississippi, what drives the number is mostly access and timing rather than distance, since hauls to our yard are usually short along the Gulf Coast. A canal pull takes more crew time than a driveway job, and hurricane season backs up the schedule every fall. The total lands inside the range in the pricing section above.
Will a junkyard or scrap yard take a fiberglass boat?
Metal pays the bills at a Mississippi scrap yard, and a fiberglass hull with a dead outboard does not carry much of it. Most yards will take the motor for scrap and wave off the hull itself, which leaves owners with half a solution. We take the entire package in one visit, dead motor, hull, and trailer, so nobody has to make two calls.
Can fiberglass boats be recycled?
To a point. The fiberglass hull typically gets ground down or routed to a specialized recycling facility built for the material, while metal parts, including whatever is left of a dead outboard, recycle through normal scrap channels. We sort each piece toward the right destination and dispose of what cannot be recycled the proper way, not the cheap way.
Can I cut up a fiberglass boat myself?
You can try, but fiberglass dust is nasty to breathe, blades chew through fast on the resin, and plenty of Mississippi landfills simply refuse the pieces once you are done cutting. Factor in Gulf Coast heat and humidity while you are out there with a saw. We cut hulls at our yard instead, away from your driveway.
Is an old fiberglass boat worth anything?
Once the motor is gone, almost never as a complete boat. The trailer, hardware, and sometimes a dead outboard still carry scrap or parts value, and we weigh that against the job when we quote it. A hull with no engine, no trailer, and stripped hardware is essentially just fiberglass and resin, worth very little on its own.
Do I need a title to dispose of a boat in Mississippi?
Mississippi's title requirements are covered in the legal section on our Mississippi boat removal page rather than repeated here. What matters for this job is that missing paperwork does not stop the pickup. We have hauled plenty of motor-dead hulls out of Gulf Coast yards with no title in hand, and the job still gets finished.
Is fiberglass boat disposal ever free?
Sometimes, if a boat still has enough value for a donation program to want it, but a dead-motor hull rarely qualifies since those programs want something that runs. Where we can help is crediting salvageable parts, the trailer, hardware, or scrap value in the motor, against the cost of the job, and we say so before you book.
